Browse SAE J ORFS O-Ring Face Fittings in the World Wide Metric, Inc. catalog including Nuts and Rings,Equal Fittings,Male Stud Coupling,Bulkhead. The Seal-Lok fitting meets or exceeds the strict requirements of SAE J and ISO It is an O-ring face seal type fitting that consists of a nut, a body. Thread Specification – ORFS (SAE J). TECHNICAL DATA. SAE J, ISO ORFS is O RING FACE SEAL. ORFS system consists of ORFS.
|Published (Last):||26 January 2016|
|PDF File Size:||17.86 Mb|
|ePub File Size:||6.2 Mb|
|Price:||Free* [*Free Regsitration Required]|
Adapter SAE J with Swivel Nut / SAE J – Standard Body On World Wide Metric, Inc.
SAE J covers the requirements for Sae j1453 face seal connectors to inch stud ends along with the associated adapters, bulkhead and union connectors. These connectors are intended for sae j1453 application see Figures 3, 4, and 5 and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures.
In the past, these connectors have been used predominantly with inch tubing. These sae j1453 are capable of providing leak proof full flow connections sae j1453 hydraulic systems operating saae 95 kPa vacuum to working pressures shown in Table 4.
Both metric and inch tubing can be accommodated by changing only the sleeve to match the tube diameters.
Adapter SAE J with Swivel Nut / BSI On World Wide Metric, Inc.
This standard is available for individual purchase. Inch hex dimensions of parts will be moved from sae j1453 main document to an informative annex after Identify unmet needs and discover next-generation technologies M1453 quality by leveraging consistent standards sae j1453 meet customer and saf requirements Minimize risk: Field of Application These connectors are intended for general application see Figures 3, 4, and 5 and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures.
Since many factors influence the pressure at which a hydraulic system will or will not perform satisfactorily, these values should not be construed as guaranteed minimums. Speed up research, capture sae j1453 reuse expertise For additional product information, sae j1453 the IHS Standards Expert page.
For any application, it is recommended that sufficient testing be conducted and reviewed by both the user and manufacturer to ensure that required performance levels are met. Mitigate liability and better understand compliance regulations Sae j1453 efficiency: The rated working pressure of a fluid conductor assembly using SAE J hose stem connections or formed tube or braze-on tube connections shall not exceed rated working pressure of the lowest rated component thereof.
For new designs metric tubing should be considered. The three parts of SAE J cover material, dimensional, and performance requirements of steel O-ring face seal ORFS connectors for tubing and the O-ring face seal interface and nut portion of hose stem assemblies for nominal tube diameters of sae j1453 mm through 50 sae j1453.
Item # 412802, Adapter SAE J1453 / SAE J514 – O-ring Body
Price and Buy this Standard View Pricing. This Standard References Showing 10 of For use of these connectors in conditions outside the pressure and temperature limits specified, the manufacturers must be sae j1453.
Click here to skip or ad will close in 15 seconds. Swe The three parts of SAE J cover material, dimensional, sae j1453 performance requirements of steel O-ring face seal ORFS connectors for tubing and the O-ring face seal interface and nut portion of hose stem assemblies for sae j1453 tube diameters of 6 mm through 50 mm.